AGA TC3 Guía de instalación descargar pdf (Pagina 15)

Fig. 12 DESN 516552

6. Slide hotcupboard onto plinth until rear tongue bracket engages fully into rear of base slot,

(See Fig. 12). Ensure the appliance is aligned squarely with the plinth then proceed to

engage the front tongue bracket into the slot on the underside of the base plate. Once

satisfied that the front tongue bracket is engaged fully lock it into place by tightening the two

M6 screws fully.

7. The hotcupboard top plate is set

/64 (5mm) higher than the AGA Total Control top plate. This

is to prevent damage to the enamel during installation. Lower the top plate using the

adjusters (See Figs. 13 and 14).

Fig. 13 DESN 516591

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Sin comentarios

AGA TC3 Guía de instalación Pagina 15